-
Jedediah replied to the discussion Implant bridge planning in the forum Implant Tx Planning a year ago
Reply to Implant bridge planning
Hello Safanah! I typically don’t stick to one general number they can range from 7 to 9 mm or even greater but much of it depends on the patients occlusion and their existing dentition. Yes, you could go old-school like some mentioned and do a model and wax up or you can just do that digitally very similar to what you did and get it pretty good…
Erick -
Nick replied to the discussion Implant bridge planning in the forum Implant Tx Planning a year ago
Reply to Implant bridge planning
So a molar is about 8 mm mesial distal. I would use opposing dentition to help determine tooth size. If you wanna go old school you can capture models and wax up some teeth. ????
Erick, Jedediah and Abbas -
Safanah replied to the discussion Implant bridge planning in the forum Implant Tx Planning a year ago
Erick and Jedediah -
Ivan replied to the discussion Implant bridge planning in the forum Implant Tx Planning a year ago
Reply to Implant bridge planning
Hi Safanah, thanks for your post. Do you have any x rays or pictures to share?
Jedediah and Erick -
Safanah started the discussion Implant bridge planning in the forum Implant Tx Planning a year ago
Hi,
I am planning an implant bridge case, planning to place 2 implants, #18 area and #20 area. Creating a guide for this and was wondering if there is a rule about the ideal distance/space to leave for a future pontic on #19 area. Thank you!
Jedediah and Erick -
Vidit replied to the discussion Angle screw drivers in the forum Implant Tx Planning a year ago
No they are not compatible.
Jedediah and Erick -
Jedediah replied to the discussion Angle screw drivers in the forum Implant Tx Planning a year ago
I don’t believe they’re compatible either
Salem, Erick and Robbie -
Vidit posted an update a year ago
Here is my first post for the implant. Pt. had extraction and Bone graft done earlier. #10 implant placed 1 week ago. Pt. was seen today and healing wnl. No pain or any complaints. Looking forward for comments and suggestions.
Jedediah, Erick and 4 others6 Comments-
Hold up, I just found out we have a guest of honor in here –My MOM! Shes a dentist too hahaha Hi mom! @litaninja
2 -
Nice job Vidit and welcome! Feedback I would give on the limited information I have would be placed the implant slightly more sub Crestal and if you’re able to drill a smaller osteotomy in the future, you might have better initial stability so you can place a healing abutment😊👍
1- View 4 replies
-
-
Ivan replied to the discussion Angle screw drivers in the forum Implant Tx Planning a year ago
When I saw your question I called up Preat, according to them, no the different systems are not meant to be compatible with one another for the ASC screws and drivers.
If you get the components from a 3rd party manufacturer like Preat or DESS, they would all be compatible with the same screw head.
Also, I asked Todd Schoenbaum (author of…
Erick, Rahul and Jedediah -
Khurrum replied to the discussion Angle screw drivers in the forum Implant Tx Planning a year ago
I do not believe so, if using authentic parts and screws, I still believe each manufacturer has a unique head on the driver.
Erick, Sowbarnika and Ivan - Load More
